毕节防腐木厂家

新闻分类

产品分类

联系我们

毕节诚达益贸易有限公司

朱先生 :18146296555

吴先生 :15882283337

网 址 :www.bjcdyffm.com

地 址 :贵州省毕节市七星关区碧阳街道居然之家斜对面诚达益防腐木


行业新闻

您的当前位置: 贵州防腐木厂家 >> 新闻中心 >> 行业新闻

施工工艺及收边处理你知道吗?

发布日期:2018-01-11 作者:贵州防腐木厂家 点击:

施工工艺及收边处理你知道吗?

贵州防腐木厂家

Do you know the construction technology and the edge treatment?
固定铺设法:用膨胀螺丝或镀锌角码把龙骨固定在地面上,膨胀镙丝应用镀锌的(抗老化比较好),,然后再用不锈钢十字螺丝在防腐木的正面与龙骨连接铺设;
Fixed laying with expansion screws or galvanized angle the keel is fixed on the ground, expansion screws used galvanized (anti aging better), and then cross in front of the keel and stainless steel screw connection laying wood preservative;
活动铺设法:
Activity shop:
第一、有规则摆好地面龙骨,再用不锈钢十字螺丝在防腐木的正面与龙骨连接;
First, there are rules to lay the ground keel, and then a stainless steel cross screw in the front of the anticorrosion wood and the keel.
第二、用螺丝把龙骨固定在防腐木反面,几块组成拼成一个整体,既不破坏地面结构,也可自由拆卸清洗;
Second. A screw is used to fix the keel on the reverse side of the anticorrosion wood. Several pieces are composed of a whole, which does not destroy the ground structure, and it can also be freely dismantled and cleaned.
第三、悬浮铺设法,龙骨在地面找平可连接成框架/井字架结构,然后再铺设防腐木。
Third, suspension laid, keel connected frame / derrick structure in ground leveling, and then came the fortification of rotten wood.
木结构基层的处理:设计施工中应充分保持防腐木材与地面之间的空气流通,可以更有效延长木结构基层的寿命。
Wood structure base treatment: in design and construction, we should fully maintain the air circulation between the anticorrosive wood and the ground, and prolong the service life of the wood structure base effectively.
制作安装防腐木时,防腐木之间需留0.2-1CM的缝隙(根据木材的含水率再决定缝隙大小,木材含水率超过30%时不应超过0.8CM为好)可避免雨天积水及防腐木的膨胀; 厚度大于50mm或者大于90mm的方柱为减少开裂可在背面中心位置开一道槽。
The production and installation of wood preservative, the gap between the wood preservative for 0.2-1CM (according to the moisture content of wood and then decide the size of the gap, the moisture content of wood more than 30% should not be more than 0.8CM as well) can avoid the expansion of rain water and wood preservative; column thickness is greater than 50mm or greater than 90mm to reduce the cracking open a slot in the center position of the back side.
五金件应用不锈钢、热镀锌或铜制的(主要避免日后生锈腐蚀,并影响连接牢度)连接安装时请预先钻孔,以避免防腐木
Hardware application of stainless steel, galvanized or copper (mainly to avoid days after rust, and the influence of connecting fastness) connection installed please pre drilled to avoid wood preservative
尽可能使用现有尺寸及形状,加工破损部分应涂刷防腐剂和户外防护涂料;因防腐木本身是半成品,毛糙部分可在铺完后等木材含水率降到20%以下,再砂光一遍,如想有更好的效果,表面清理干净后亦可涂刷户外防护涂料(如有颜色的保护涂料应充分搅匀)。如遇阴雨天,最好避免施工。
The use of the existing size and shape as far as possible, processing damaged parts and outdoor protective coatings with preservatives; because wood preservative itself is semi rough part after spreading and wood moisture content below 20%, then sanding again, if you want to have a better effect, the surface clean up after brushing or outdoor protection paint (such as protective coating color should be fully stir). In case of rainy days, it is best to avoid construction.
表面用户外防护涂料或油漆类涂料涂刷完后,为了达到最佳效果,48小时内避免人员走动或重物移动,以免破坏防腐木面层已形成的保护膜。如想取得更优异的防脏效果,必要时面层再做一道专用户外木油处理。
After coating the surface with outdoor protective coatings or paint, in order to achieve the best effect, avoid moving or heavy moving within 48 hours, so as not to destroy the protective film that has been formed on the surface of the wood preservative. If you want to get more excellent anti - dirty effect, it is necessary to do a special outdoor wood oil treatment when necessary.
由于户外环境下使用的特殊性,防腐木会出现裂纹、细微变形、属正常现象,并不影响其防腐性能和结构强度。
Because of the particularity used in outdoor environment, the anticorrosion wood will appear crack, fine deformation and normal phenomenon, which does not affect its anticorrosion and structure strength.
一般户外木材防护涂料是渗透型的,在木材纤维会形成一层保护膜,可以有效阻止水对木材的侵蚀,清洁可用一般洗涤剂来清洗,工具可用刷子。
The general outdoor wood protective coating is permeable, and a protective film is formed on wood fiber. It can effectively prevent the erosion of water to wood. Cleanliness can be cleaned by general detergent, and tools can be brushed.
1年至2年左右做一次维护;用专用的木材水性涂料或油性涂料涂刷即可。更多防腐木、青岛防腐木、山东防腐木、防腐木栈道、红柳桉、碳化木、炭化木、深度炭化木、南方松、美国南方松以上是贵州防腐木厂家处理防腐木的施工工艺及收边过程;
1 to 2 years to do a maintenance; use special wood water-based paint or oily paint paint. More wood preservative, Qingdao Shandong wood preservative, wood preservative, wood preservative plank, red eucalyptus, carbonized wood, carbonized wood, carbonized wood, depth of southern pine, the southern pine above is the construction technology of Guizhou wood processing factory and anticorrosive wood edging process;

本文网址:http://www.bjcdyffm.com/news/444.html

相关标签:贵州防腐木厂家

最近浏览:

贵公网安备 52050202001223号

欢迎给我们留言
请在此输入留言内容,我们会尽快与您联系。
姓名
联系人
电话
座机/手机号码
邮箱
邮箱
地址
地址